I have been working with Mossberg Customer Support to compile a list of repair parts (all the parts that are not requiring gunsmith credentials) for Mossberg MVP owners. I hope this helps everyone out.
MVP 7.62
​
Extractor- #17126- $9.00
Extractor detent- #1561- $3.50
Extractor spring detent- #17128- $3.50
Ejector- #17129- $4.95
Ejector spring- #17130- $3.50
Ejector pin- #17089- $3.00
Bolt head cross pin- #18801BL- $4.25
Bolt stop spring- #17078- $1.94
Bolt stop- #19275BL- $10.00
Bolt stop screw- #17104BL- $3.25
Front action screw- #101531- $2.50
Rear action screw- #101532- $2.50
Trigger guard- #100810- $10.00
Trigger guard screw- #17653- $2.50
​
MVP 5.56
​
Extractor- #19550- $9.00
Extractor detent- #1561- $3.50
Extractor spring detent- #18541- $2.25
Ejector- #103226- $3.25
Ejector spring- #17130- $3.50
Ejector pin- #17089- $3.00
Bolt head cross pin- $19539BL- $5.50
Bolt stop spring- #17078- $1.94
Bolt stop- #19275BL- $10.00
Bolt stop screw- #17104BL- $3.25
Front action screw- #17142- $2.50
Rear action screw- #101532- $2.50
Trigger guard- #17876- $10.00
Trigger guard screw- #17653- $2.50
thankyou for the list , can I ask if you have had anything break yet , my MVP 7.62 is still fairly low rounds , I am just wondering if there should be anything I should be watching for.
Quote from: TrapperPete on September 06, 2018, 05:16:42 PM
thankyou for the list , can I ask if you have had anything break yet , my MVP 7.62 is still fairly low rounds , I am just wondering if there should be anything I should be watching for.
I have not had anything break as of yet and I tend to run my rifles pretty hard. I just want to make sure that I have the parts available should anything go sideways for me.
I was initially very concerned about the "strength" of the duck lip on the bottom of the 5.56 MVP bolt but as of approx 2300 rounds it has not broken yet...not for the lack of abuse I dare say.