I have the Daniels Defense A1.5 on my AR15, I replaced the Windage adjuster with the DPMS Rapidex Knob. It used a 1/16 roll pin. The Tech Sight seems to have a smaller roll pin. I'm using a Snap-On roll pin punch that measures to the correct diameter. I would really like to install a Rapidex Knob on the tech sights. It has 10 adjustments per rotation vs the 5 on the tech sight.
Somewhere on here there's a thread on how to do this. I want to say they're Winchester rapid adjustment knobs but I don't remember since I didn't convert mine. I'll loop in my buddy DryFire. He'll know.
Like this?
Oooh! Shiny. Where do I get one?
http://www.midwayusa.com/product/353544/dpms-rear-sight-base-rapidex-windage-knob-ar-15-a1-matte
UL
I put rapidex knobs on both of my 10/22 LTRs. I utilized a cut off finish nail/brad nail to drive the existing pin out. If I remember right I then also re-used the pin with the new knob. The fun part was compressing the spring while also lining up the holes. I resorted to utilizing a clamp to compress the spring and hold the knob on while I drove the pin.
DryFire
Now, if only there was a Rapidex knob for elevation...
UL
That is just what Iwas thinking. The little wrench is a pain. I use the screwdriver on the leatherman to turn the wheel.
Quote from: Stand on June 09, 2014, 08:46:48 PM
That is just what Iwas thinking. The little wrench is a pain. I use the screwdriver on the leatherman to turn the wheel.
Yup. On my SKS, I use the tip of a bullet. It's just so slow.
UL
I plan on painting the groves different colors as well to make it easire to see if it has moved or just slipped. On the SKS I think it may just be easier to use the front sight to adjust elevation. I have it installed I now need time to SHOOT it. :wb: