Print Page - 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix

Title: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: Kosciusko on May 11, 2012, 02:14:11 PM

picked up an older Ruger 10/22 a couple days ago

the price was right, still is, IMO

walnut stocked, 119-xxx series 16.5 inch carbine

some mods had been done, the first indication was the jeweled bolt

plastic aftermarket extended mag release - all the early 10/22s had the recessed mag release, it will be replaced

swapped in a VQ speed bolt release, which isn't working, but the extended mag release is worn/wobbly and may be the culprit.

a more serious issue:

close the bolt, with safety on , squeeze the trigger, hammer doesn't fall

push the safety off, finger nowhere near the trigger, and the hammer falls, every time

not good

prime suspects: sear, trigger, hammer, safety, probably in that order

what sucks is that the trigger is reaaaalllllyy good

swap 1 part out at a time ?

anybody got spares? I know, Midway

Thanks,

k

Title: Re: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: Edheler on May 11, 2012, 02:51:32 PM

Have you disassembled and cleaned the fire control group yet?

Title: Re: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: douglas34474 on May 11, 2012, 02:55:11 PM

Somebody has worked the hammer notch too much. You can upset the safety leg of the sear to properly fit the safety. You literally hammer the left edge if the sear to made the safety leg longer.

Title: Re: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: TxBobS on May 11, 2012, 04:56:48 PM

There is an observation hole (that's what I'm calling it :)) that lets you see the hammer engagement to the sear. Sounds like that there is such a small amount that when pressing the trigger the hammer is being disengaged and then only resting on the safety. Put your thumb on the hammer and watch it through that hole.

My bet is someone messed up a trigger job. You shoud also watch and make sure that there is a positive engagement. That is that the hammer moved backwards still as the trigger is pressed.

Title: Re: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: Kosciusko on May 11, 2012, 05:25:16 PM

I will clean it thoroughly over the weekend and take a look at the other stuff mentioned.

Thanks to all,

k

Title: Re: 10/22 problem-squeeze trigger, take safety off, hammer falls --> need fix
Post by: douglas34474 on May 11, 2012, 06:16:12 PM

Quote from: Kosciusko on May 11, 2012, 02:14:11 PM
anybody got spares? I know, Midway

Thanks,

k

The hammer and sear are restricted parts from the factory. Shooters Discount lists OEM hammers and sears, but are sometimes out of stock.

There are of course after market parts, however, you can make the ones you have work. ;)

Send me a PM if you need help.

Doug

Project Appleseed

Road to Rifleman => Rifle / Ammo / Gear => Topic started by: Kosciusko on May 11, 2012, 02:14:11 PM